Momo Near Branson Again?

This is for anything not covered by other forums here, it's the general discussion forum.
Forum rules
This forum will sometimes contain copyrighted information, however, it is placed here under Title 17

Not withstanding the provisions of sections 106 and 106A, the fair use of a copyrighted work, including such use by reproduction in copies or phonorecords or by any other means specified by that section, for purposes such as criticism, comment, news reporting, teaching (including multiple copies for classroom use), scholarship, or research, is not an infringement of copyright.
Post Reply
admin
MABRC Chief Forum Administrator, MABRC Executive Director
MABRC Chief Forum Administrator, MABRC Executive Director
Posts: 2702
Joined: Sat Oct 12, 2019 9:34 am

Momo Near Branson Again?

Post by admin » Mon Nov 11, 2019 11:35 pm

Author: gojohn111 [ Sun Oct 18, 2015 7:02 pm ]
Post subject: Momo Near Branson Again?
A television morning news anchor from Ky3 in Springfield, Missouri went camping with her family this weekend at Mill Creek campground by Kimberling City, outside of Branson a few miles. Anyway, her family went for a hike around the campground shore and found tracks of raccoon, deer, & something with a 5 foot stride(I have a good idea). Go to her facebook website of Maria Neider and watch the short video she made. Maybe there is some credibility to the Table Rock Lake pictures near Kimberling City that someone discounted as a hoax. I have camped many times at or near the same campsite, but always had the A/C running or was more concerned with the fishing by there inside of being more observant. Will now!

Author: gojohn111 [ Sun Dec 20, 2015 9:50 pm ]
Post subject: Re: Momo Near Branson Again?
Maria took her original post on the KY3 facebook and put it on Youtube. Here's the link to view.

Author: Rebelistic [ Mon Dec 21, 2015 8:30 am ]
Post subject: Re: Momo Near Branson Again?
gojohn111 wrote:
Maria took her original post on the KY3 facebook and put it on Youtube. Here's the link to view.
It sure wouldn't surprise me if it wasn't a legit print and if the stride was measure correctly it also seems to make it possible. Just never saw any measurements of the print itself.

Post Reply

Return to “General Discussion”


  • You do not have permission to post in chat.
@ admin « Thu 9:09 pm »
Just to get the chat going, it’s going to take some time to move over all the data, but in the end, hope everyone likes the layout here.

Who is chatting

offline admin